---- Sparkle Pheasant Tail Nymph ----
Hook:Tiemco #2487 (caddis/scud hook)
Bead:Gold 1/8" (size#10) 3/32" (size#16)
Thread:Black 8/0
Tail:Peasant tail fibers
Rib:Med./Small copper wire
Abdomen:Pheasant tail fibers
Sparkle:Pearl Krystal Flash and white Z-Lon
Thorax:Peacock herl
Hosted and created by Mountain Anglers; © 2008-2009
Slip the bead onto the hook and make several wraps of .020" lead wire behind it on the shank. Trim wire and push it up against the bead. Tie in thread (i’ll often use black 6/0 for this step) and wind back and over the the lead wraps and secure them. Using the thread, create a taper as shown. This will help the pheasant tail fibers take a nice form when wrapped.
Wind thread back, and tie in the copper wire.
Trim approx. 8 pheasant tail fibers from a tail feather (ringneck pheasant) keeping the tips aligned as much as possible. Tie in as the tail and wind forward to secure it.
Wind the copper rib forward and tie off.
Tie in a piece of white Z-Lon, approx. 2/3s of a strand.
Double up a strand of Krystal Flash and tie in, ahead of Z-Lon. Gently hold the Krystal flash in a rearward direction, and wind back your thread to the Z-Lon’s tie-in point. This will keep them facing back.
Tie in 4 pieces of peacock herl and wind forward creating the thorax. Tie-off and trim the butts of the herl.
This recipe is compliments of Rob O'Reily.
Trim the Krystal Flash to the desired length, and do the same for the Z-Lon. NOTE: I like the Krystal Flash to be slightly longer than the Z-Lon. Make several wraps of thread behind the bead, trim it and add a few drops of head cement.
Completed Sparkle Pheasant Tail Nymph.
